Description
Oatey PVC Rain-R-Shine Cement is formulated for wet conditions or situations involving fast installation or pressurization of PVC pipe and fittings up to 6″ diameter with interference fit.
Very fast setting
Recommended for pool, irrigation, potable water, pressure pipe, conduit and DWV
Recommended application temperature 40°F to 110°F / 4°C to 43°C
No primer needed on non-pressure DWV, up through 6″ diameter where local codes permit
Meets ASTM D2564
Prior To Use:
Stir or shake cement before using. If jelly-like, do not use. Keep container closed when not in use. Avoid eye and skin contact. Wear safety glasses with side shields and wear rubber gloves
Square pipe ends, chamfer and remove all dirt
Check dry fit of pipe and fitting. Pipe should easily go 1/3 of the way into the fitting. If pipe bottoms, it should be snug
Use a suitable applicator at least 1/2 the size of the pipe diameter. For larger size pipe systems use a natural bristle brush or roller
Clean pipe and fitting with a listed primer. (Do not use primer on ABS pipe and fittings. Use Clear Cleaner only!)
Apply liberal coat of cement to pipe to the depth of the socket, leave no uncoated surface
Apply a thin coat of cement to inside of fitting, avoid puddling of cement. Puddling can cause weakening and premature failure of pipe or fitting. Apply a second coat of cement to the pipe
Assemble parts QUICKLY. Cement must be fluid. If cement surface has dried, recoat both parts
Push pipe FULLY into fitting using a 1/4 turning motion until pipe bottoms
Hold pipe and fitting together for 30 seconds to prevent pipe push-out longer at low temperatures. Wipe off excess
Allow 15 min for good handling strength and 2 hrs cure time at temperatures above 60°F before pressure testing up to 180 psi. Longer cure times may be required at temperatures below 60°F or with pipe above 3″. DO NOT TEST WITH AIR
Reviews
There are no reviews yet.