YakAttack MightyMount Switch

Description

With an identical hole pattern as old school deck mounts this mount can be used to switch to a deck mount that accommodates modern track accessories without the need to drill more holes. Compatible with the YakAttack LockNLoad mounting system and with other MightyBolt accessories. For kayaks with pre-threaded inserts, additional hardware may be required.

Made in the USA

Instructions for Inflatable Kayaks

Locate the red bag of hardware containing nuts, washers and LONG screws and discard them. They will not be used for inflatable kayak installs

Position the MightyMount Switch on your YakAttack SwitchPad or other inflatable mounts

Locate the short 1/4-20 x 5/8″ long stainless screws in the bag labeled, “Hardware for Inflatable Installs”

Insert a short screw into each hole of the MightyMount Switch

Hand tighten with a Phillips Screwdriver until snug. Repeat steps 3 and 4 for the rest of the hardware

After all screws are installed, fully tighten, being careful not to over tighten

Instructions for Rotomolded and ABS Kayaks

Locate the Hardware for Deck Mount Installs

Position the MightyMount Switch on the surface where you want to install it

Using a hole in the MightyMount Switch as a guide, drill the first hole using a 17/64″ drill bit

Drop a long 1/420 screw through the MightyMount Switch and into the drilled hole. This will prevent the MightyMount Switch from sliding around as other holes are drilled

Repeat steps 2 and 3 for the rest of the holes

Once all holes are drilled, remove all screws

Apply marine sealant as desired into hole and on screw threads

Install first screw with washer and nut on inside of hull, but do not fully tighten

Repeat steps 6 and 7 for remainder of screws

After all screws are installed, fully tighten, being careful not to over tighten

Note

Please do not use Loctite or a threadlocker that reacts with plastics